1. Remove Rubber Insert From Channel, Drill Or File Rivot Hole To 5mm

2. Mount Crash Bar Lower L-Brackets, Usually Centre Whole Depending On Model

2A. Nip Up 8mm Bolt L-Bracket To Crash Bar

3. Fit The 2 Hooks To Leg Sheild And Do Up Nut M6.(Do Not Fully Tighten)

Line Up Crash Bar Then Tighten Up All Fixings In A Staggered Formation Keeping Crash Bar Level As You Tighten

When Finished Screw Threaded Rubber Boot On End Of T-Piece Arm.